En-14
9.2. Install panel to unit
(1) Install the cassette grille on the indoor unit.
“DRAIN” mark
“PIPE” mark
* Align the stamped marks on the cassette grille to the pipe and the
drain of the indoor unit.
Screw
CAUTION
Use only the supplied screws to install the cassette
grille.
Indoor unit
Ceiling
No gap between ceiling and
cassette grille around entire
perimeter
3/16 to 4/16 in.
(5 to 7 mm)
Cassette grille
Sealant
(2) Connect the connector.
Wire (louver): WHITE
Wire (display): WHITE
Wire (louver): RED
Indoor unit side
• Arrange the wires as illustrated.
(3) Attach the connector cover.
Screw
Connector cover
9.3. Attach the intake grille
The installation is the reverse of “8.2. Remove the intake
grille”.
The intake grille can be rotated and installed 4 ways to suit
the user’s preference.
CAUTION
The louver angle cannot be changed if the power is not
on. (If moved by hand, it may be damaged.)
The grille assembly is directionally relative to the air
conditioner body.
Install so that there is no gap between the grille assembly
and the air conditioner body.
The cassette grille is equipped with an accessory to
prevent the grill to completely open. Be sure to read
the Installation manual included with the cassette grille
before installation.
10. FUNCTION SETTING
This procedure changes the function settings used to control
the indoor unit according to the installation conditions. Incor-
rect settings can cause the indoor unit to malfunction. This
procedure should be performed by authorized installation or
service personnel only.
Perform the “Function Setting” according to the installation
conditions using the remote controller. (Refer to the indoor
unit installation manual for details on the function numbers
and setting values.)
(1) Press the SET TEMP. buttons ( ) ( ) and FAN button
simultaneously for more than 5 seconds to enter the func-
tion setting mode.
SU MO TU WE TH FR SA
9374318599-02_IM.indb 14
9374318599-02_IM.indb 14
9/26/2018 11:04:20 AM
9/26/2018 11:04:20 AM
