MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
2
) more than 3 sec-
onds and less than 10 seconds on the main unit control pan-
el.
To stop operation, press the MANUAL AUTO button (Fig. 2
2
) for 3 seconds.
●
When the air conditioner is operated
by the controls on the MANUAL AUTO
button, it will operate under the same
mode as the AUTO mode selected on
the Remote Controller (see page 7).
●
The fan speed selected will be “AUTO”
and the thermostat setting will be stand-
ard (24
°C
).
10°C HEAT OPERATION
•
The room temperature can be maintained at 10°C by pressing the 10°C HEAT button
(Fig.5
F
) so as to prevent the room temperature from falling too far.
•
In case of multi-type air conditioner, if other indoor unit is used for heating, the
temperature of the room where the “10°C HEAT” function is applied will rise. When
using the “10°C HEAT” function, we recommend all indoor units should be run under
the“10°C HEAT” mode.
To use 10°C HEAT OPERATION
Press the 10°C HEAT button (Fig.5
F
)
The OPERATION indicator lamp (green) (Fig. 3
5
) will go out, and the ECONOMY indi-
cator lamp (green) (Fig. 3
7
) will light.
To stop 10°C HEAT OPERATION
Press the START/STOP button (Fig.5
K
)
Then the operation stops.
About the 10°C HEAT Operation
•
The Heating mode will not operate if the room temperature is high enough.
While 10°C HEAT OPERATION is in
progress, only the following operation
can be used.
• SET
OPERATION
●
Indicator Lamp
:
Lighting :
OFF
TIMER
ECONOMY
CLEANING AND CARE
●
Before cleaning the indoor unit, be sure to turn it off and disconnect the Power Supply Cord.
●
Be sure the Intake Grille (Fig. 1
8
) is installed securely.
●
When removing or replacing the air
fi
lters, be sure not to touch the heat exchanger, as personal injury
may result.
CAUTION!
●
To avoid excessive wear of the part and components or malfunctioning of the air conditioning, the user/consumer shall perform
preventive maintenance through an accredited technical assistance, periodically. To know the preventive maintenance perio-
dicity, the consumer shall check with the accredited installer or an accredited technical assistance.
●
When used for extended periods, the indoor unit may accumulate dust inside, reducing its performance. We recommend that
the indoor unit be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized serv-
ice personnel.
●
It is recommended for the user/consumer to demand a copy of the Work Order every time there is a visit of a technical assist-
ance for veri
fi
cation, maintenance, test or repair of the product.
●
When cleaning the indoor unit’s body, do not use water hotter than 40°C, harsh abrasive cleansers, or volatile agents like ben-
zene or thinner.
●
Do not expose the indoor unit’s body to liquid insecticides or hairsprays.
●
When shutting down the indoor unit for 1 month or more,
fi
rst allow the fan mode to operate continuously for half a day to allow
internal parts to dry thoroughly.
En-12
9332280029-04_OM.indb Sec1:12
9332280029-04_OM.indb Sec1:12
2/25/2013 3:27:52 PM
2/25/2013 3:27:52 PM
