En-12
To use 10 °C Heat operation
Press the “10 °C HEAT” button.
The Operation indicator lamp (green) will go out, and the Economy indicator lamp (green)
will light.
While the 10 °C Heat operation is in
progress, only the following
operation can be used.
•
Swing operation
REMOTE CONTROLLER CUSTOM CODE SETTING
When two or more air conditioners are installed in a room and the remote controller is operating an air conditioner other than the
one you wish to set, change the custom code of the remote controller to operate only the air conditioner you wish to set (4 selections
possible).
When two or more air conditioners are installed in a room, please contact your retailer to set the individual air conditioner custom
codes.
Use the following steps to select the custom code of the remote controller. (Note that the air conditioner cannot receive a signal if it
has not been set for the matching custom code.)
●
If no buttons are pressed within 30 seconds after the custom code is displayed, the system returns to the original clock
indicator display. In this case, start again from step 1.
●
The air conditioner custom code is set to “A” prior to shipment. Contact your retailer to change the custom code.
●
The remote controller resets to custom code “A” when the batteries in the remote controller are replaced. If you use a
custom code other than “A”, reset the custom code after replacing the batteries.
If you do not know the air conditioner custom code setting, try each of the custom codes (A → B → C → D) until you fi nd the
code which operates the air conditioner.
1
Press the “START/STOP” button until only the clock
indicator is displayed on the remote controller
display panel.
2
Press the “MODE” button for at least fi ve seconds to
display the current custom code (initially set to A).
3
Press the “SET TEMP.” buttons
(
/
)
to change the
custom code between
A B C D
. Match the code on
the display panel to the air conditioner custom code.
4
Press the “MODE” button again to return to the clock
indicator display. The custom code will be changed.
10 °C HEAT OPERATION
About 10 °C Heat operation
• The Heating mode will not operate if the room temperature is high enough.
• The room temperature can be maintained at 10 °C by pressing the “10 °C HEAT” button so as to prevent the room temperature from
falling too far.
To stop 10 °C Heat operation
Press the “START/STOP” button.
Then the operation stops and the Economy indicator lamp (green) will go out.
NOTES:
In simultaneous multi connection, this function by using the wireless remote controller cannot be used.
9374379736-03_OM.indb 12
9374379736-03_OM.indb 12
03-Jul-18 13:09:16
03-Jul-18 13:09:16
