Fujitsu Siemens Computers KVM series2-1611, User Manual

Page: 45 / 57

Operations
Figure 24: Network Configuration Menu
4.10.1.1 Accessing the Terminal menu
Connect a terminal or PC running terminal emulation software (such as
HyperTerminal) to the configuration port on the back panel of the KVM s2-
1611 using a RS232 DB9 null modem cable. The terminal should be set to
9600 baud, 8 bits, 1 stop bit, no parity and no flow control. The terminal may
be connected at any time, even when the unit is powered.
Press any key to access the main menu.
4.10.2 Network Configuration
The KVM s2-1611 is configured for network access through the Network
Configuration option. When it is selected, you will have access to the addressing
that allows the KVM s2-1611 to be positioned in your network. For more
information, see
Installing the KVM s2-1611
in Chapter 3.
4.10.2.1 Firmware Management
This menu option contains the FLASH Download command. The FLASH Down-
load selection allows you to keep your KVM s2-1611 firmware current with up -
grades available from Fujitsu Siemens. For more information, see Chapter 5.
4.10.2.2 Enable Debug Messages
This menu option allows you to configure the KVM s2-1611 to display messages
regarding the status of the KVM s2-1611. Once you select the level of detail to receive,
the KVM s2-1611 will begin to display information on your terminal screen. When you
are finished viewing, press any key to exit this mode.
4.10.2.3 Set/Change Password
The KVM s2-1611 can be set to a secure mode where the Terminal menu cannot
Network Configuration
590-332-501E 37