６．How to use
① Fill screws up to or below the referende line
in the hopper.
Refill after finished using up the last loaded screws.
Do not let malformed,different type screws or metal
scrap get mixed in with the screws you are loading.
Do not use screws that were picked up by magnets
or that are coated with oil.
② Turn on the power switch
The three digit LED lamp then light up
and the rotating drum starts turning.
Screws are then fed along the chute and the unit
rotates for a fixed quantity of screws. The rotating
drum automatically stops when the screws are
aligned and the motor lamp turns off.
Do not point the screw feed hose tip at other persons. The screws
may fly outwards creating a hazardous situation.
③ Send a screw feed signal from external source.
Sending a first signal causes the escapement to
move back and forth one time, sorts out one screw
on the chute,and sends it by compressed air
along the screw feed hose to a specified location.
Never point the tip of the screw feed hose
at someone since the screw may fly outwards
causing injuries or hazardous situations.
If using the VIS SETTER Handy as the screwdriver,
you can send a feed screw signal from the
screwdriver switch to the VIS SETTER by
retracting-extending the Y-pipe on the driver
one time by hand as shown in the figure.
CAUTION
Reference
line
When using screwdriver
R
et
rac
t
o
r
ext
rnd
- 12 -
