8
Installation
8
4
Ensure that there is no deformation such as flattening.
Remove an inner panel by loosing 4 or 6 screws.
3. Referring to “Installation Diagram”, insert 4 wooden screws into a
bottom plate of the cabinet.
Marking is recommended before screw.
About 5mm between the bottom plate and screwheads for hanging
the hood body.
4. Hook the temporary fixing holes of the body with screws, then slide
the body backward until the screws are engaged in a narrow end of
the holes.
Ensure proper hood position, and tighten 4 screws.
5. Tighten 2 screws of the rear.
6. Assemble the hood in reverse procedure of section 2.
7. Connect Ø150 flexible duct to the exhaust port. (not supplied)
Note
Make the length of the duct as short as possible.
The longer the exhaust duct, the lower the ventilation.
5mm
4
确保没有变形如压扁。
松动
4
颗或
6
颗螺钉，取下内板。
3.
按照“安装示意图”所示，在橱柜板底部埋设
4
颗木螺钉。
建议在拧入螺钉前标注记号。
在橱柜底板与螺钉头之间预留
5mm
，以便悬挂机体。
4.
将螺钉钩入机身的临时固定孔，将机体后推直至螺钉全部
挂住小孔。
确保吸油烟机位置准确，然后拧紧
4
颗螺钉。
5.
拧紧
2
颗后螺钉。
6.
根据与第二部分的相反操作安装吸油烟机。
7.
将
Ø1
50
软管连接在排气口上。（非提供品）
注意：
尽可能使用短排气管。
排气管越长，通风性能越差。
5m
m
