Installing the appliance
Sponge
Bottom view
The thickness of the sponge is 3 mm.
The width of the sponge is 10 mm.
Place the bracket
(B) over the holes that match the size
of the screws.There are one set of screw holes
(H)
in
each
corner of the hob.
Slightly tighten a screw
(C) through the bracket
(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position .
.
2 Carefully turn the hob back over and then gently lower
it
into the aperture hole that you have cut out.
.
3 On the underneath of the hob, adjust the brackets into
a
position that is suitable for your worktop.
Then fully tighten the screws
(C) to secure the hob into
position.
(C) SCREW
(B) BRACKET
1
8
(A) SEALING STRIP
(H) SCREW HOLES
Remove the pan supports, the burner
cap
and flame spreader and carefully turn
the
appliance upside down and place it
on a cushioned mat.
Take care that the Ignition devices and
flame
supervision devices are not damaged
in this operation.
2. Apply the sponge provided around the
edge of
the appliance.
3.
1.
Do not leave a gap in the sealing agent or
overlap the thickness.
1.
7KLVZLOOPDNHLWGLI¿FXOWWRUHPRYHWKH
DSSOLDQFHIURPWKHDSHUWXUHLQIXWXUH
SDUWLFXODUO\LILWQHHGVWREHVHUYLFHG
Do not use a silicon sealant to seal the
appliance against the aperture.
FH-GS6030 SVGL/SVSS
FH-GS6020 SVGL/SVSS
CAUTION:
In case of hotplate glass breakage:
- shut immediately off all burners and any electrical heating element and isolate the
appliance from the power supply
- do not touch the appliance surface,
- do not use the appliance.
This appliance is not connected to a combustion products evacuation
device. It shall be installed and connected in accordance with current
installation regulations. Particular attention shall be given to the relevant
requirements regarding ventilation
Summary of Contents for FH-GS6020 SVGL
Page 1: ...FH GS6020 SVSS FH GS6030 SVSS FH GS6020 SVGL FH GS6030 SVGL ...
Page 24: ......
