Page 4
Parts List
Part
Description
Qty
1
Transmitter
1
2
Receiver
1
Part
Description
Qty
3
Assembly Hardware
1
10.
Do not overreach.
Keep proper footing
and balance at all times. If a ladder
is to be used during installation, it
should be supported by an assistant.
11.
Do not set up the Alert System
if under the influence of alcohol
or drugs.
Read warning labels on
prescriptions to determine if your
judgement or reflexes are impaired
while taking drugs. If there is any
doubt, do not set up the Light.
13. The warnings, precautions, and
instructions discussed in this instruction
manual cannot cover all possible
conditions and situations that may
occur. It must be understood by the
operator that common sense and
caution are factors which cannot
be built into this product, but must
be supplied by the operator.
IMPORTANT SAFETY INFORMATION
1.
Position batteries in proper polarity
and do not install batteries of
different types, charge levels,
or capacities together.
2.
Keep installation area clean.
Cluttered areas invite accidents.
3.
Observe installation area
conditions.
Keep work area
well lit during installation.
4.
Check for damaged parts.
Before
using any product, any part that appears
damaged should be carefully checked
to determine that it will operate properly
and perform its intended function.
Check for any broken or damaged
parts and any other conditions that may
affect its operation. Replace or repair
damaged or worn parts immediately. Do
not use the Alert System if any switch
does not turn on and off properly.
5.
Replacement parts and accessories.
When servicing, use only identical
replacement parts. Use of any
other parts will void the warranty.
6.
Keep children away.
Mount the Sensor
and Receiver out of children’s reach.
7.
Dress properly.
Protective,
electrically non-conductive
clothes and nonskid footwear are
recommended when working with
the Alert System. Wear restrictive
hair covering to contain long hair.
8.
Use eye protection.
Wear ANSI-
approved impact safety goggles
when setting up this product.
12.
Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of
the power tool is maintained.
9.
Maintain products with care.
Keep the
Alert System clean for better and safer
performance. Inspect the components
periodically. If damaged, have it
repaired by a qualified technician.