Page 3
b. Mount the Sensor at least 1m
above the ground. If placed under
the garage eaves, be sure that the
Sensor is not blocked by the roof
facia board.
c. If placed above 2m high,the Sensor
should be aimed downward so that
it is pointed toward the area being
monitored.
4. Mount the Receiver to a flat surface
with hardware (not included), or stand
on a flat surface. The receiver is not
intended to be weather resistant.
Note:
Do not install the receiver in a
location that will get wet or directly
exposed to the elements.
Operation
Power Switch
The Power Switch has three settings:
a. Off: Power is off.
b. Low: A short beep will sound
(approximately 80dB) and the LED
will flash when motion is detected.
c. Hi: A loud beep will sound
(approximately 92dB) and the LED
will flash when motion is detected.
Operation
1. To operate the Driveway Alert, slide
the Power Switch on the Receiver
to the “Hi” setting. Allow 30 seconds
for warm-up. Two short beeps will
sound, indicating the unit is working.
2. Test the Sensor by walking or
driving into the protected area.
Another person should be listening
for the alarm to sound.
3. If the Sensor does not activate,
Sensor relocation or aiming
adjustment will be required.
4. If the Receiver does not activate with the
sensor, reposition them closer together.
5. Once you have determined that the unit
is working properly, leave in the “Hi”
setting or adjust to the “Low” setting.
Low Battery
1. When the Sensor batteries need
changing the LED on the Sensor
will turn on. Replace the batteries.
2. When the Receiver batteries
need changing, the center
LED on the Receiver will turn
on. Replace the batteries.
Cleaning Maintenance and Lubrication
1.
BEFORE EACH USE,
inspect the
general condition of the tool. Check for:
•
leaking, swollen, or cracked batteries,
•
loose hardware,
•
misalignment or binding of parts,
•
cracked or broken parts, and
•
any other condition that may
affect its safe operation.
2.
AFTER USE,
wipe external surfaces
of the tool with clean cloth.
3. Replace the batteries in the
Receiver or Sensor when their low
battery LED indicator lights.
4. There are no replaceable parts on
the Receiver or Sensor units.