background image

クイックメンテナンスガイド

(XQ1用防水プロテクター)

※防水プロテクターをご使用の際は、必ず携帯してください。

取り付けを確認しよう

指でOリングを全周なぞって、段差
や異物の有無を確かめよう。

Oリングはカメラを水もれから守
る非常に大切な部分です。
メンテナンスをしっかりと行い正
しく使いましょう!

Oリング

ここを確認! !

• Oリングに傷やひび割れがないか?
• Oリングに異物が付着していないか?
• Oリングと密着する壁面一周(

A

面)に異

物が付着していないか?

• Oリングがねじれて取り付けられていない

か?

水もれさせないために、念入りに確認
しよう!

防水プロテクターを開けるときは…

水滴をよく拭こう

開ける前に、必ずよく拭こう。

使い始める前にもう一度確認しよう

Oリングを指でなぞって、異物の付着がないか確認しよう。
このとき、Oリングと密着する壁面も指でなぞると効果的。

こんな状態で防水プロテクターを開けないで!!

● 風が強くてほこりが

舞っているとき

● 防水プロテクターに

水滴が付いているとき

● 水しぶきがかかるようなとき

防水プロテクターのご使用前の取り扱い方法と事前チェック、メンテナンス、ご使用後の
保管方法などの詳細は使用説明書をご覧ください。

JP

QUICK MAINTENANCE GUIDE 

(Waterproof Case for the XQ1)

* Always carry this Maintenance Guide with you when using the Waterproof Case.

Check the fi t.

Run your fi nger around the entire 
O-ring to check for bulges or foreign 
particle on the ring.

O-rings are extremely important 
since they prevent water leaking 
into the camera.
Regular and careful maintenance 
will ensure that you get the 
maximum enjoyment from your 
camera.

O-ring 

Check for these!

•  Are the O-rings damaged or cracked?
•  Is there any foreign particle stuck to the 

O-rings?

•  Is there any foreign particle stuck to the rear 

surface flange (

A

) that fits onto the O-ring?

•  Are there any twists in the O-ring when it is 

fitted?

Check carefully to prevent leaks!

WHEN OPENING THE WATERPROOF CASE…

Carefully dry the case.

Always wipe the case dry before opening it.

Check again before using the camera.

Run your fi nger around the O-ring to check that there 
is no foreign particle on the ring. It’s a good idea to run 
your fi nger around the rear surface fl ange that fi ts onto 
the O-ring.

Do not open the Waterproof Case in these situations!

 In strong wind 

when there is dust 
or grit in the air

 When the Waterproof 

Case is wet

 When water spray might get 

into the case

Wind

Dust

Refer to the Owner’s manual for information on handling and checking the Waterproof Case 
before use, storing the Waterproof Case after use, and Waterproof Case maintenance.

EN

GUIDE D’ENTRETIEN RAPIDE 

(Boîtier étanche pour le XQ1)

* Lorsque vous utilisez le caisson étanche, gardez ce guide d’entretien à portée de main.

Vérifi ez que le joint torique 
est correctement installé.

Passez vos doigts le long du joint 
torique afi n de détecter de possibles 
ondulations ; veillez également à retirer 
toute particule déposée sur le joint.

Les joints toriques sont très importants, 
car ils empêchent la pénétration d’eau 
dans l’appareil photo.
Un entretien régulier des joints vous 
permettra d’utiliser votre appareil 
photo de façon optimale.

Joint torique 

Procédez aux vérifi cations suivantes

•  Les joints toriques sont ils endommagés ou 

fissurés ?

•  Des particules sont-elles déposées sur les 

joints toriques ?

•  Des particules sont-elles déposées sur 

l’embase (

A

) fixée sur le joint torique ?

•  Le joint torique installé sur le caisson est-il tordu ?

Pour éviter les fuites, vous 
devez toujours procéder à ces 
vérifi cations avant utilisation !

LORSQUE VOUS OUVREZ LE CAISSON ÉTANCHE…

Séchez soigneusement le 
caisson.

Il est important de toujours sécher le 
caisson avant de l’ouvrir.

Avant de réutiliser l’appareil photo, 
procédez aux vérifi cations.

Passez vos doigts le long du joint torique afi n de 
retirer toute particule déposée sur le joint. Passez 
également vos doigts le long de l’embase fi xée sur 
le joint torique.

N’ouvrez jamais le caisson étanche dans les situations suivantes !

 S’il y a trop de vent, 

de poussière et de 
particules dans l’air

 Si le caisson étanche 

est humide

 Si de l’eau a pénétré à 

l’intérieur du caisson

Reportez-vous au mode d’emploi pour de plus amples informations concernant les précautions à 
prendre avant d’utiliser le caisson étanche, le stockage et l’entretien du caisson après utilisation.

FR

Vent

Poussière

Reviews: