Quick Start Guide to the Vevo 770
®
Rev. 1.7
Page
5
EKV™ Reconstruction
1.
Check the ECG monitor to ensure that the system is producing a
consistent, strong ECG signal.
2.
Connect the RMV scanhead to the Vevo Integrated Rail System III arm
mount.
3.
Acquire a B-Mode image.
4.
Select Setup > B-Mode Setup, or press <Mode Setup> to change
acquisition parameters.
5.
Click Start EKV or press <EKV™>. The progress bar beneath the image
area tracks the EKV acquisition. When acquisition ends, the EKV loop has
been acquired.
6.
To save the acquired EKV data, press <Cine Store>.
3D-Mode
1.
Connect the 3D motor stage to the Vevo Integrated Rail System III.
2.
Connect the RMV clamp to the 3D motor stage.
3.
Connect the RMV scanhead to the RMV clamp.
4.
Select Setup > 3D-Mode Setup or press <Mode Setup> to change the
acquisition parameters.
5.
Click Init. 3D to initialize the 3D motor stage.
6.
Click Start 3D. The 3D motor stage begins stepping along the acquisition
route.
7.
To save the acquired 3D data, press <Cine Store>.
Power Doppler Mode
1.
In B-Mode acquisition, identify the target region for Power Doppler
acquisition.
2.
Select Overlay > Power Box Wire-frame or press <Overlay> until the
Power Doppler Mode sample volume is displayed.
3.
Position and size the sample volume to include the target region for Power
Doppler signal acquisition on the B-Mode image.
4.
Switch to Power Doppler Mode from B-Mode by selecting Mode > Power
Doppler Mode, or by pressing <Power>.
5.
Start and stop data acquisition using <Scan/Freeze>.
Note: Power Doppler Mode is also supported in 3D-Mode. To acquire Power-
3D-Mode data, from the Power Doppler Mode image click Start 3D. The 3D
motor stage begins stepping along the acquisition route.
