FujiFilm UA125x8BESM-S35, Operating Manual

Page: 32 / 84

-･iv･-
(1) Before Installing onto Camera
When･it･is･required･to･install･this･lens･on･a･Sony･studio･camera･(Ex.･HDC-4300)･or･on･a･Sony･large･lens･adapter･
(Ex.･HDLA-1500),･remove･the･pin･on･the･bayonet･mount･of･the･lens,･and･attach･it･to･the･threaded･hole･in･the･
mount･frame.･･To･install･this･lens･on･another･camera,･reinstall･the･pin･on･its･former･position.･
(2) Caution when using the lens supporter
When･using･this･lens･with･a･Fujinon･lens･supporter･(ELH-*)･attached,･use･a･power･source･connecter･(see･ “Name･
and･Function･of･Each･Part”)･to･supply･power･from･the･lens･side.･If･power･is･not･supplied,･correct･operation･may･
not･occur.
(3) Enclosure of Desiccant
The･inside･of･this･lens･is･able･to･enclose･desiccant･in･order･to･eliminate･humidity･that･may･mist･the･surfaces･of･the･
internal･glasses.･･A･desiccant･bag･for･storage･was･enclosed･in･the･desiccant･enclosure･place･before･shipment･at･the･
factory.･･Prior･to･use,･take･out･this･bag･first,･and･put･new･desiccant･bags･in･that･place･as･follows:･
a.･There･are･twelve･desiccant･bags･in･the･trunk.･･Take･out･two･of･them･to･use.･･The･rest･should･be･used･when･the･
exchange･of･the･desiccant･is･required.
b.･Loosen･the･two･lens･shroud･attaching･knobs･on･the･both･sides･of･the･lens.･･Draw･the･shroud･towards･the･front･of･
the･lens･to･detach･it･from･the･body.
c.･Remove･the･four･screws･to･take･off･the･lid.
d.･Take･out･the･desiccant･bag･for･storage.
e.･Fold･new･desiccant･bag･and･put･it･in･the･desiccant･enclosure･place.
f.･Put･the･detached･lid･in･its･place･and･reinstall･the･four･screws.･･Finally,･reinstall･the･lens･shroud.
Note 1. Perform the above procedure in a dust-free place.
Note 2. In a humid region, it is recommended to change the desiccant bags two times a year. The desiccant
being jellied indicates the time when it must be exchanged.
THREADED HOLE
PIN
NEW DESICCANT BAG
DESICCANT BAG
FOR STORAGE
DESICCANT ENCLOSURE PLACE
PRIOR TO USE