FujiFilm FUJINON HA14x4.5 BEZD-T58B, Operation Manual

Page: 58 / 108

①
③
In a zoom operation with an analog zoom demand control unit, the zoom mode function (function of selecting
the characteristics of “zoom speed vs zoom control signal” ) can be switched to ON and OFF.
Note.
The characteristics of “Zoom Speed
vs Rotational Angle of Zoom Seesaw
Control Lever” can be selected from
ten modes.
Refer to the following figure.
⑤
④
Set this switch to “OFF” when a malfunction occurs and it is assumed that the malfunction is caused
by a serial communication failure.
②
FUNCTION & MODE SELECT SWITCHES
Rubber Cap
④
AUXILIARY SWITCH
ANALOG ZOOM DEMAND
ZOOM MODE FUNCTION ON/OFF SWITCH
③
②
QUICKFRAME ON/OFF SWITCH
①
CAMERA COMMUNICATION ON/OFF SWITCH
⑤
ZOOM MODE SELECT SWITCH
The illustration shows the positions set at the factory.
Camera Communication ON/OFF switch
This switch changes the function of serial communication with a camera to ON and OFF.
QuickFrame ON／OFF switch
This switch changes the quickframe function to ON and OFF.
Zoom Mode Function for Analog Zoom Demand ON/OFF Switch
Auxiliary switch An
auxiliary switch.
Zoom Mode select switch
Maximum
No.9
No.4(Normal)
No.0
W T
0
Rotational Angle of zoom seesaw control lever
- 20 -