202B1262871D
3.6.2 Inspecting the Bending Mechanism
[Note] For information on how to operate the bending mechanism, refer to “2.6 Operating
Bending Section” of this manual.
“2.6 Operating Bending Section”
(1) Unlock both up-down and left-right angulation locks by
turning them in the “Free” direction (F ).
(2) Turn the up-down and left-right angulation knobs in the U,
D, L and R directions until they stop.
Check that bending section turns smoothly.
When the angulation knob is released, the bending section
should move toward its neutral position.
(3) Turn the up-down and left-right angulation locks in the
direction opposite to F , and then lock them.
(4) Turn the angulation knobs in similar manner as in step (2),
and check how the bending section angulates.
Check that the bending section maintains its angulated
position after the angulation knobs are released.
(5) Turn the up-down and left-right angulation locks in the
direction of F to unlock them.
Chapter 3 Preparation and Inspection Before Use
57
EG580UR_E2-50_202B1262871D.indb 57
2016/07/04 16:07:00