Fuji Xerox DocuPrint CM505 da, Administrator'S Manual

Page: 294 / 599

9 Scanner Environment Settings
294
Sc
an
n
er
En
vir
o
n
m
en
t Se
ttin
g
s
9
Configuration of Network Scanning (Job Template Scanning)
This section describes how to configure the machine to use the Network Scanning
service.
The following shows the reference section for each procedure.
Step 1 Preparations....................................................................................................................294
Step 2 Enabling Ports and Setting up TCP/IP...........................................................................294
Step 3 Configuring the SNMP Port...........................................................................................295
Step 4 Configuration on the Computer .....................................................................................296
Step 1 Preparations
The following environment is required to use the Network Scanning feature on the
machine.
z
To use SMB forwarding, your computer must run on one of the following operating
systems that supports folder sharing.
- Microsoft Windows NT 4.0
- Microsoft Windows 2000
- Microsoft Windows Server 2003
- Microsoft Windows Server 2008
- Microsoft Windows Server 2008 R2
- Microsoft Windows XP
- Microsoft Windows Vista
- Microsoft Windows 7
Step 2 Enabling Ports and Setting up TCP/IP
To use Network Scanning service, enable the port and set the IP address. The
following describes the configuration procedures on the machine.
Note • You can configure the settings using CentreWare Internet Services. For information on how
to use CentreWare Internet Services, refer to "Configuring Machine Settings Using
CentreWare Internet Services" (P.255).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2
Enable the SNMP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SNMP], and then select [Change Settings].