Fuji Xerox ApeosPort-V 4020, Administrator'S Manual

Page: 113 / 611

Common Service Settings
113
Tools
5
Note • You cannot configure the machine not to switch to the Low Power mode or the Sleep mode.
„
From Last Operation to Low Power Mode
Specify a time period between 1 and 30 minutes in 1 minute increments to enter the Low
Power mode after the last operation.
„
From Last Operation to Sleep Mode
Specify a time period between 1 to 60 minutes in 1 minute increments to enter the Sleep
mode after the last operation.
Note • Configure the [From Last Operation to Sleep Mode] time to be same or longer than the [From Last
Operation to Low Power Mode] time.
•
The machine enters Sleep mode without entering Low Power mode when the [From Last Operation
to Low Power Mode] time is same as the [From Last Operation to Sleep Mode] time.
Scheduled Power Off
You can set a time for the machine to be automatically turned off.
„
Disabled
Does not turn off the machine automatically.
„
Enabled
Set a time for the machine to be automatically turned off.
Note • [Disabled] is set by default.
• Even when [Enabled] is set, the machine will not be automatically turned off during an error (such as
paper jam) or processing (such as copying, printing, interruption).
Audio Tones
Select whether to sound an alarm when a job ends or a fault occurs.
Control Panel Select Tone
Set the volume to be sounded when a button on the control panel is correctly selected.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Control Panel Alert Tone
Set the volume to be sounded when a button that cannot be selected is selected, or an error
occurs.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Base Tone
Set the volume for the base tone of the toggle button, which changes setting each time it is
pressed. The machine plays this sound when it exits the Interrupt mode.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Machine Ready Tone
Set the volume to be sounded when the machine is ready to copy or print, or powered on.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Job Complete Tone 1, 2
Set the volume to be sounded when a job is completed normally.