Page
15
of
28
Fuji Electric Europe GmbH
7.1.2
Overview of operation modes
TP-E1U keypad can operate in the modes shown in table 8.2.
Table 8.2. Keypad operation modes
Operation mode
Description
Running mode
The inverter cannot be operated by this keypad. Running mode is only to monitor Run status.
Programming mode
This mode allows you to configure function code data and check a variety of information relating to the inverter status
and maintenance.
Alarm mode
If an alarm condition arises, the inverter automatically enters Alarm mode in which you can view the corresponding
alarm code* and its related information on the LED monitor.
* Alarm code: Indicates the cause of the alarm condition. For details, please refer to Chapter 15.
Figure 8.2 shows the status transition of the inverter between these three operation modes.
Programming mode
Configuration of function
code data and monitor of
maintenance/alarm info
and various status
Alarm mode
Display of alarm status
Occurrence of
a heavy alarm
(Press this key if
an alarm has
occurred.)
+
Running mode
Monitor of running status
Power ON
Release of
a heavy alarm
Figure 8.2. Status Transition between Operation Modes
Simultaneous keying
Simultaneous keying means pressing two keys at the same time. The simultaneous keying operation is
expressed by a "+" letter between the keys throughout this manual.
For example, the expression "
+
keys" stands for pressing the
key with the
key held down.
7.1.3
USB connectivity
The keypad has an USB port (Mini-B connector) on its front. To connect an USB cable, open the USB port cover as
shown below. The position of the USB port is shown in figure 8.3.
Figure 8.3. Position of USB port.
For the instructions on how to use the FRENIC Loader 4, refer to the FRENIC Loader Instruction Manual.
7.1.4
TP-E1U Menu
Partial menu list can be accessed by pressing
.
In order to have all menus available please set E52=2.
0.
Quick Setup (0.Fnc)
Display only basic function codes to customize the inverters operation.
1.
Data Setting (From 1.F_ _ to 1.K_ _ )
Selecting each of these function codes enables its data to be displayed/changed.
2.
Data Checking (2.rEP)
Display only function codes that have been changed from their factory defaults. You can refer to or
change those function code data.
