MT5F22233b
1. Scope of application
© Fuji Electric Co., Ltd. All rights reserved.
2
Fig.1 Terminal shape before and after the press-in process to the printed circuit board
(b) Terminal shape after the press-in process
(a) Terminal shape before the press-in process
ＰＣＢ
ＰＣＢ
EconoPIM
TM
and EconoPACK
TM
are registered trademark of Infineon Technologies AG, Germany.
This document describes how to safely mount and use press fit type of EconoPIM
TM
and
EconoPACK
TM
products for the following part numbers shown in Table 1.
Press fit type : Products that can be mounted solder less to printed circuit board (PCB)
Press fit terminals have the characteristic shape shown in Fig.1(a). When the press fit terminal is
pressed into the PCB, contact pressure is applied from both sides of the terminals, and they were
deformed and inserted as shown in Fig.1(b). The deformation pressure makes it possible to mount the
product on the PCB solderless.
When handling the product, in addition to the contents described in this document, please check the
Warning and Caution in the product specification too.
