11
FE
48
ELLIPTICAL
4
PLASTIC COVERS
1.
Install Right Connecting Arm Cover
(86)
and Left Connecting Arm Cover
(85)
on the rod end bearing on the front of left connecting arm and use
two M5 × 15m/m_Phillips Head Screws
(121)
, one 3.5 × 12m/m_Sheet
Metal Screw
(124)
to secure with Short Phillips Head Screw Driver
(161)
.
Same steps for another pair of covers for the right connecting arm.
2.
Install Left and Right Sliding Wheel Covers
(101&102)
on each side and
secure with four Phillips Head Screws
(121)
.
3.
Install the two Stabilizer Covers
(96 and 97)
on the middle stabilizer bar
with two Phillips Head Screws
(121)
.
4.
Install Left Front Handle Bar Cover
(87)
and Left Rear Handle Bar Cover
(88)
at the joint on left Lower Handle Bar and use three 3.5 × 12m/m_Sheet
Metal Screws
(124)
to secure with Short Phillips Head Screw Driver
(162)
.
Same steps for installing Right Front Handle Bar Cover
(89)
and Right Rear
Handle Bar Cover
(90)
and securing three 3.5 × 12m/m_Sheet Metal
Screws
(124)
to secure with Short Phillips Head Screw Driver
(162)
at the
joint on right Lower Handle Bar.
5.
This step to be performed after the elliptical power is plugged in. Elevate
the incline to Level 8 and install the Incline Bottom Cover
(98)
up against
the middle stabilizer tube with two Phillips Head Screws
(121)
.
6.
At last, press Rear Bar Cover
(100)
onto Inclinable Rail Assembly at the rear.
Hardware Step 4
#121
.
M5 ×15m/m
_Phillips Head Screw
(12 pcs)
#124.
3.5 ×12m/m_
Sheet Metal Screw
(8 pcs)
