FuehlerSysteme FS6002, Instructions For Use Manual

Page: 47 / 70

47 - 70 71130/11E/0318
Command HS
<id>HS<para5> Height Settings.
Access: Configuration mode (ADMIN).
Description:
This command determines if the station height is set manually by the command “SH”,
or automatically acc. to GPS level. The station height is necessary for the calculation of
the air pressure on sea level.
Parameter description:
0: T
he station height is set to “SH”, and is not readjusted by GPS.
1: The station height is
averaged, and is stored after14 days as fixed “SH”
parameter, the parameter “HS“ is reset afterwards.
2: As 1, however the parameters are not stored permanently, the height averaging
starts again after each re-start.
3:
Sets the station height acc. to the instantaneous value of the GPS receiver.
Value range: 0..3
Initial value: 1 (only article: 4.9200.xx.xxx and 4.9202.xx.xxx)
Command HT
<id>HT<para5> Heating control (Heating).
Access: Configuration mode (ADMIN).
Description: In order to avoid a malfunction of the precipitation radar and the brightness sensors,
caused by snowfall and ice formation, the Weather station is equipped with a cover
heating.
Parameter description:
0: Heating always off.
1: Heating switches on with air temperatures below 5°C.
2: Heating permanently on with a heating power level of 50%.
This setting should only be used for testing and switches
back automatically to "1" when parameters are saved.
3: Heating switches to 100% for 60s.
Value range: 0..3
Initial value: 1
Command ID
<id>ID<para5> WEATHER STATION devices (IDentifier)
Access: Configuration mode (ADMIN)
Description: This command is used to specify the identification number of the WEATHER
STATION.
The ID is required to address the WEATHER STATION with every command.
Whenever its ID is changed, the WEATHER STATION will respond to its new identifier
immediately.
The ID 99 is an universal ID. Every WEATHER STATION will always respond to
commands with the ID 99 (with the correct baud rate).
The ID 99 must not be used in bus mode under any circumstances.
Example: 00KY04711 Open with user key.
00ID00023 Change ID from 0 to 23.
!00ID00023 WEATHER STATION acknowledges change.
23DM Query of duplex mode with new ID.
!23DM00000 Response from WEATHER STATION.
23ID00000 Change ID from 23 to 0.
!23ID00000 WEATHER STATION acknowledges change.
Value range: 0..99
Initial value: 0