Fubag INMIG 200 Plus, Operator'S Manual

Page: 5 / 32

5. orch T
www.fubag.ru
O m perator's anual
- - 5
The torch is composed by torch stand, connecting cable and handle.
Torch stand is the interface of torch and wire feeding device.
Connecting cable: covered by nylon pipe the liner is loaded in the center of coreless cable. The inner
part of liner is the passage for wire feeding. The space between liner and coreless cable is the
passage for shielded gas. Coreless cable is the passage for current.
There is a gooseneck installed in the handle of the torch. In the back part of the torch there is a
connecting with the coreless cable and in the front part is a shunt. The shielded gas distributes via
the shunt and forms well-proportioned air current in the nozzle, and then spurt out in a form of air
hanging. Set with a sensitive switch on the handle to control the welding current.
Must cut off the power before assemble/disassemble torch or replace the components.
The nozzle must be replaced in time on the condition that welding quality was influenced when it
burned to some extent. The distributor of torch must be replaced when it ruined.
The cable of torch must be replaced when it worn out.
-
-
-
Notice:
SWITCH HANDLE
STAND GOOSENECK
SHUNT
CONTACT
TIP
CABLE
RUBBER LAYER
CONTROL CABLE
CORELESS CABLE
NYLON PIPE
WIRE
SPRING PIPE
NOZZLE
Environment to Which the Product Is Subject:
Requirement for Main Supply:
- The surrounding temperature range: when welding: -10 + 40 С;
During transport or in storage: -25 +55 С
- Relative humidity: when at 40 С: ≤50%,
20 С: ≤ 90%
- The dust, acid and erodible materials in the air can not exceed the amount required by the norm
(apart from the emissions from the welding process). No violent vibration at the job site.
- Keep from raining when it is used outdoor.
- Altitude no more than 1,000m.
- The oscillation of the supplied voltage should not exceed ±15% of the rated value.
О
О
О О
when at