Fubag INMIG 200 Plus, Operator'S Manual

Page: 14 / 32

www.fubag.ru
O m perator's anual
- 4 - 1
-
-
-
-
-
-
- .
-
Regularly check the seal performance of gas system, whether the fan and feeder motor having
abnormal sound and whether every joint being loose.
Keep torch cable direct when welding.
Regularly clean the splash of nozzle (cannot use the way similar to knocking the torch head) and
stick to using splash ointment. Don’t remove the feeder device by means of pulling he torch cable.
Use qualified wire, no using inferior or rusty wire.
Clean the dust of liner with compressed air after the welder using some time (the dust is
accumulated by friction between wire and liner roll if find it wear and tear to prevent wire uneven
feeding.
The pressed roll can not be pressed too firm to guarantee smooth wire feeding. (It will lead to wire
deformation, adding the feeding resistance and accelerating the friction of gear if pressed over
firmly.)
- The main loop voltage happens to be a bit higher, so safety precaution should be taken before
repair to avoid accidental shock. The untrained people are forbidden to open the case.
Power source needs to be cut off before dust removal
Never tamper with wire or damage the component parts when cleaning.
WARNING: