background image

www.fubag.ru

O

m

perator's

anual

-

-

1

1.

- Do not use in any cases to charge small batteries or for non rechargeable batteries.
-  Scheme of the charger contains the elements and nodes, under voltage mains. Strictly

prohibited to work when removing siding.

- To work with the device allowed a person trained, instructed and knowledge test electrical

safety, with qualifying group on electrical safety, not lower than III and the corresponding
certificate.

- When the battery stands out explosive gas. Therefore, in a room where there is a charge of

battery should be adequate ventilation and fire safety measures complied with (prohibited
use of fire, smoking, and avoid the formation of sparks, security in conformity with the
means of fire extinguishing, etc.).

- It is not intended for use outdoors. Exclude moisture and electrolyte on the device.

Prohibited from placing the device inside the vehicle.

- Do not use the device in the absence or ground fault. Before connecting the appliance,

check availability and serviceability of grounding.

- Unplug the power cable from the wall outlet when moving the machine, before maintenance

and repair, connecting and disconnecting the battery.

- Position the machine in the room so that the panel should be easily accessible.
- Install the unit on a firm, level surface.
- Carefully read the instruction manual and battery charge from the manufacturer, prior to its

charge.

- Replace the network cable, repair and maintenance staff should be given only a qualified

service center.

- Do not charge defective batteries. This will lead to damage to the machine. To exclude the

loss of charging current and sparks before charging well you clean the battery terminals of
the oxide film.

- Do not leave your charger plugged on your car when you start it. It can break the fuse.
- Do not use your charger like an auxiliary power supply.
-  It is forbidden to pull up current from the battery when the battery is connected to the

charger.

Safety peration

o

WARNING! BEFORE USING THE CHARGER READ THE INSTRUCTION
MANUAL CAREFULLY! FOR QUALIFIED AND SPECIALLY TRAINED PERSONS
ONLY AFTER PROPER READING OF THIS MANUAL IS ALLOWED TO USE AND TO
MAINTAIN THIS DEVICE.

The detailed description, safety rules and all required information necessary for proper operation
and maintenance of FUBAG charger are provided below. Keep this instruction manual by charger
and refer to it by any doubts concerning safety operation, maintenance storage and handling of
FUBAG charger.

Summary of Contents for DRIVE 1200/24T















Reviews: