Fume hoods
Soldering - Desoldering
Specialized tools for wiring and tinning
Hand tools, consumables and workshop equipment
–
+33(0)1 40 86 00 09
–
4
4. INSTALLATION / MOUNTING OF EQUIPMENT
- Put the hood on a flat and horizontal surface to prevent it from tipping over.
- In the event of an external discharge: Fix the discharge pipe in such a way as not to introduce any stresses
that are detrimental to stability.
- Unscrew the rear grille from the box
- Slide the 125 mm diameter hose onto the collar
- Secure the hose using the clamp provided
- Take care to extend the hose to the point of external discharge, avoiding elbows as much as possible.
- Check that the length of the power supply cable is compatible with the distance between the hood and the
power plug.
- Check that this socket has single-phase alternating grounded current wire 230 V, 50/60 Hz. It must be secured
by a protection system guaranteeing the safety of the user.
- Open the front panel and position the appropriate filter for the intended use.
Installation of the activated carbon filter (identical for the particulate filter or external discharge)
- Unscrew the knurled knob on the front face of the hood and tilt the face.
- Install the filter (first remove the tip that may be attached to the filter frame).