Fume hoods
Soldering - Desoldering
Specialized tools for wiring and tinning
Hand tools, consumables and workshop equipment
–
+33(0)1 40 86 00 09
–
3
The use of the hood without rejection to the outside is possible in certain specific cases where:
- The nature and concentration of the pollutants are well controlled
- Continuous verification of the capacity of the filtering element is ensured
The filter, mounted in a metal box, adapts to all hood models and has the following characteristics:
-
3. SAFETY RECOMMENDATIONS
This device is not intended for use by persons (including children) whose physical, sensory or mental
capabilities are impaired; or persons without experience or knowledge, unless they have been able, through a
person responsible for their safety, to have prior surveillance or instructions concerning the use of the device.
Children should be supervised to ensure that they do not play with the appliance.
WARNING: BEFORE ANY INTERVENTION (FOR EXAMPLE FILTER REPLACEMENT) BE SURE TO DISCONNECT
THE HOOD.
- Avoid aspiration of liquids as well as acid products. In case of error, immediately stop operation, clean and dry
the splashed parts thoroughly, before restarting the installation.
- Avoid the aspiration of the flames. These can damage the Filter as well as the booth.
- Avoid contact with very hot or incandescent parts.
- Avoid working in a damp room.
Reference
Designation
Classification
PFP1
Protection pre-filter (batch of 10)
G3
PF3
Protection pre-filter (batch of 10)
M5
FPP1
Dust filter for outer rejection
G4
FAP1
Particle filter for internal recycling
M5
FCP1
Activated carbon filter (vegetal, for solvents and gas)
N/A
FCP1 min
Activated carbon filter (mineral) for aceton
N/A
FCP1 blend
Activated carbon filter combined with alumine and
KMnO4 (Formaldéhyde and other products)
N/A
FCP1-FT
H2SO4
Activated carbon filter impregnated with sulfuric acid
(for alcali)
N/A
FCP1-FT KOH
Activated carbon filter impregnated with potass (for
acids)
N/A