PAG.37
rev 1.0
OSD 80
OSD 81
1. LNB Power: If your receiver is connected to the LNB direct-
ly then you need to set the LNB Power to “On”. If your receiver
is connected to a multi switch (SMATV signal distribution sys-
tem) then it may be that you don’t need to provide the power
to the LNB. But since this is depending on the kind of installed
distribution system we recommend you to contact your install-
er or to refer to the user manual of this system to get the cor-
rect information.
You also just can change this setting and check if you still can
receive the channels. If the LNB Power is off and you still can
see all channels then we recommend this setting.
2. Press [Exit] button to leave this menu.
5.7. RCU POSITION SWITCH
In order to avoid interferences between remote controls, you
have the possibility to change the code of it, to do that you have
to change the position of a switch in the remote control.
But fi rst of all you have to change this code in the receiver. You
can do this in the menu “RCU Position” (OSD 80).
You have to select the same position in the receiver than in the
remote control (OSD 81).
SYSTEM SETUP
ENGLISH
Summary of Contents for MAX S102E
Page 1: ...MAX S102E...
