TYPICAL APPLICATION
LAPTOP
VIDEO
T2-CATXW
FRONT
T2-CATXW
BACK
RJ-45
TWISTED PAIR
UP TO 1000'
T2-CARX-S
BACK
T2-CARX-S
FRONT
VIDEO
TO AC
POWER
TO AC
POWER
1
2
Boost
Picture Adjust
Off
T2-CARX-S
Gain
Skew Compensation
Channel
Next
Right
Left
Power
Options
On
Computer A/V Receiver
R
Power
Out
Gnd
L
12VDC/0.3A
UTP Input
from Twister 2
Transmitter
Audio
Video Out
Computer A/V Receiver
9VAC/0.6A
AUDIO IN
SIGNAL
POWER/
COMPUTER IN
T2-CATXW
UTP OUTPUT
TO TWISTER 2
RECEIVER
12VDC/0.1A
9VAC/0.2A
POWER
244 Bergen Blvd.
West Paterson, NJ
07424
AUDIO
AUDIO
PROJECTOR
AUDIO AMP
AUDIO IN
SIGNAL
POWER/
COMPUTER IN
T2-CATXW
1.70
4.09
.93
.27
2.72
UTP OUTPUT
TO TWISTER 2
RECEIVER
12VDC/0.1A
9VAC/0.2A
POWER
244 Bergen Blvd.
West Paterson, NJ
est Paterson, NJ
07424
1
2
3.69
4.10
4.22
1.59
Boost
Picture
Adjust
O
ff
T2-CARX-S
Gain
Skew Compensation
Channel
Next
Right
Left
Power
Options
On
Computer
A/V ReceiverA/V Receiver
R
Power
Out
Gnd
L
12VDC/0.3
A
UT
P
Input
from
T
wister 2
T
ransmitter
Audio
V
ideo Out
Computer
A/V ReceiverA/V Receiver
9
V
AC/0.6
A
DIMENSIONS
Once the interconnect cables are tested, connect the system as per the
diagram and perform the fi nal operation check.
Audio wiring:
See the pinouts for wiring details
Connect the audio source to the T2-CATXW Transmitter via the 3.5mm
stereo audio jack on the face of the unit. Connect the T2-CARX Re-
ceiver’s 3 pin pluggable screw down terminal audio output
to the house
sound system
System Calibration and Adjustments
Setting the Boost Switch:
The Boost” switch is located on the right front of the T2-CARX receiver
unit.
For Cat5 cable runs less than 200’, leave the “Boost” dip switch in the
OFF (UP) position. For 200-1000’ runs place the “Boost” dip switch in
the ON (DOWN) position.
System Calibration setup:
For best results the following test patterns will be required:
• A crosshatch pattern with one pixel wide vertical and one pixel
high horizontal lines.
•Standard SMPTE color bars.
•A full width one on/one off burst pattern.
These test patterns will need to be output from the source equipment
(computer, DVD player, etc.) that you intend to connect to the T2-
CATXW Transmitter.
If possible, perform a display calibration without the Twister by connect-
ing the source directly to the display device using a short (less than 25
foot) video cable. Use the burst pattern to set the display size, phase and
pitch as per the display manufacturers instructions. Most displays will
have an “auto sync” function that will get you close, but might require
some additional fi ne-tuning.
Once the display is set, connect the source and display to the Twister2
