F
F
F
F
FS
S
S
S
SR
R
R
R
R
in
in
in
in
inc
c
c
c
c .....
244 Bergen Boulevard, West Paterson, NJ 07424 Tel 973-785-4347 Fax 973-785-3318 E-Mail [email protected]
AUDIO PRODUCT GROUP
The audio outputs are screw terminal connectors and can be wired one of two ways:
For balanced lines (the usual case):
H
H (Hi)
L
L (Lo)
S
S (Shield)
For unbalanced lines (using standard mic cable)
Hi / red
Hi / red color
Lo / black
Lo / black color ( the shield conductor is tied to the
black conductor at receiving end).
SYSTEM SET UP (TURN ON)
OPERATE MUSIC:
Referring to the audio hookup diagram, connect the room microphones, and room amplifiers. Connect the
background music source to the MUSIC INPUT located on the rear of the Audio Control Unit. Set each
wallplate as shown below. Check to make sure the input trim pot (MUSIC GAIN) on the rear of the unit is
set midway. Play some music and then adjust the amplifier volume for equal loudness in each room (this is
very important).
Only readjust the GAIN SET (located on the rear of the Audio Control Unit) to maintain a comfortable level in each
room if the music source has a very low output (not usually the case).
ML-104
Outputs
