FSR MAS-6100, Installation And Operating Manual

Page: 13 / 54

13
MAS-6100 / MAS-6100A
In both Genlock and Lock & Mix modes the source selected for the lock input determines the resolution of the
Output image. The output resolution for the entire image can be no different than the resolution of the lock
source. All synchronization signals are re-generated within the unit so they may look slightly different when
compared on an oscilloscope to the original source.
NOTE:
Before turning the Lock feature on, you fi rst must select a valid Lock source. Not all Lock sources
are available, depending on the main Input source in use (see “Scaler Adjust Group” NOTE). For instance, you
cannot overlay one CV or YC source over a different CV or YC source, or one RGB1 and RGB2 source over
another RGB1 and RGB2 source – you are restricted to overlaying CV/YC over RGB1 and RGB2, or RGB1 and
RGB2 over CV/YC (the exception is where you can overlay one source over itself).
1024 x 768 60Hz 1024 x 768 60Hz
Output res. [28] Output res. [28]
Your unit can handle a very wide array of inputs and convert them all to a single output signal with defi ned
characteristics. This output resolution will remain in place until changed or it may be overridden by the lock
mode and source.
The top line of the display will show the current output resolution selected.
Output Adjust Output Adjust
Output type [RGBHV] Output type [RGBHV]
This menu item allows you to select the type of signal output your unit will provide. Types of output vary
depending on the resolution selected and include various types of component signals Y/R-Y/B-Y or YPbPr, the
full range of RGB type signals RGBHV, RGBS and RGsB (Sync on green).
Output Adjust Output Adjust
Back Y/U/V [ 16] [128] [128] Back Y/U/V [ 16] [128] [128]
Sets the value of the fi xed background color, which is present when Dissolve is used with no Lock source
background displayed.