FSR BMS-1032 BACKGROUND MUSIC SYSTEM
EXPANSION CARD INSTALLATION
Remove the 10 top cover screws and top cover on the BMS-1032 controller to access the main chassis.
Remove the next blank cover plate in the numerical sequence by removing the two 6-32 cover plate screws.
There are two jumpers on each expansion card that identify whether it is an upper or lower board with respect to
its position on the chassis.
Set jumper pins as indicated below:
UPPER CARD SETTING
LOWER CARD SETTING
JP1
JP1
1 2 3
1 2 3
JP 2 JP2
JP 2
Install plastic standoffs (supplied) if needed to mount the expansion board into the chassis. Install the expansion
board by inserting the RJ45 jack array into the open slot and snapping the rear of the card onto the two standoffs.
Replace one of the two cover plate screws in the left threaded hole to secure the new expansion board.
The ribbon cables are already installed on the BMS-1032 chassis.
The connector in the middle of the ribbon cable connects a lower card. The connector at the end of the ribbon
cable connects to an upper card. Open the “ears” at the rear of the board and attach the appropriate ribbon cable
to the board. Close the ears to lock the cable in place.
Repeat this procedure for each additional expansion card.
Install a “test” BMS-1032 wallplate into each of the new outputs to test the new card(s).
Replace the 10 top cover screws and top cover on the BMS-1032 controller to complete the installation.