FSN FS-L3202D, User Manual, Page: 21 / 40

FSN1986 - 11/2017
English - 21
Submenus for the following signal types:
VGA Analog, RGBS
After selecting a main menu category, press the
+
button to enter the associated submenus as
shown below. Next, use the UP and DOWN buttons to navigate to the desired submenu,
then adjust as needed with the
+
and
-
buttons. Select the MENU button to exit from the
submenu or main menu.
Submenus under the ADJUST menu
1. BRIGHTNESS Increases or decreases the brightness. (Range : 0~100)
2. CONTRAST Increases or decreases the contrast. (Range : 0~100)
3. CLOCK Increases or decreases the sampling frequency. (Range : 0~100)
4. PHASE Increases or decreases the phase level. (Range : 0~100)
5. BACKLIGHT Adjusts backlight dimming level. (Range : 0~100)
6. AUTO ADJUST fits to the most appropriate screen on the D-SUB Analog /
RGBs signal.
Submenus under the COLOR SETTING menu
1. SELECT Changes the image color setting. (MODE A,B)
2. MODE Changes the color mode. (C1, C2, C3, USER)
3. RED Red balance. (Only works with USER mode) (Range : 0~255)
4. GREEN Green balance. (Only works with USER mode) (Range : 0~255)
5. BLUE Blue balance. (Only works with USER mode) (Range : 0~255)
Submenus under the IMAGE menu
1. SCALING MODE Changes the image size. (FILL ASPECT, 1:1,FILL H, FILL V)
2. H POSITION Adjusts the horizontal position of the displayed source image.(Range : 0~100)
3. V POSITION Adjusts the vertical position of the displayed source image. (Range : 0~100)
4. GAMMA Adjusts GAMMA value. (BYPASS,1.8, 2.0, 2.2, 2.4, 2.6, PACS, V0, V1, V2)
5. SHARPNESS Sets the sharpness of image. ( Softest, Soft, Normal, Sharp, Sharpest)
6. OVER SCAN Adjusts the displayed size. (0~8)
7. ZOOM / PAN Enlarges the image, moves images left and right.
8. FREEZE Keeps the image still.
9. DYNAMIC RANGE Select a video range. (0~255 or 16~235)
Submenus under the SETUP menu
1. LANGUAGE Changes the OSD language. (9 languages)
2. TRANSPARENCY Adjusts the OSD background from white opaque to translucent.
3. OSD POSITION Changes the OSD position. (9 Positions)
4. OSD TIMEOUT Adjusts the length of time the OSD Menu is present on the
screen. (5, 10, 20, 30, 60, 90, 120, 180, 240 seconds)
5. RESET SETTINGS Changes all the OSD values to factory default.
6. AUTO INPUT SELECT Disables or enables auto source select. (ON: Searches
through all possible input sources until an active video source is found.
OFF: Video input is manually selected.)
7. INACTIVE INPUT Change the input source between RGBs and YPbPr.
8. PICTURE DELAY Adjust the picture delay. (0: Disable deinteracer engine,
1: Enable deinteracer engine)
9. KEYPAD BUZZER Turn the keypad buzzer sound on or off.
Submenus under the PIP menu
1. LAYOUT Changes the layout. (OFF, PIP, PBP1. PBP2)
2. INPUT Changes the secondary source.
3. SIZE Changes the PIP size. (Small, Large)
4. POSITION Changes the PIP position.
5. SWAP Swaps the position of the Primary and Secondary images.