FSA GT1-70 Quick Start Manual Download Page 10

Rev. 21/09/2020 
 

Definitions 

¹ Water Filter Systems are defined as systems designed for drinking water under our Water filter Systems, Reverse Osmosis Systems & Ultraviolet 
Sanitation Categories – Excluding Cartridges and Shower Filters.  
² Other products not manufactured or assembled by FSA are covered under the applicable manufacturer’s warranty. 
³ FSA specifies recommended or required filter maintenance – see product information for further details. If a maintenance schedule is not 
specified, filter maintenance is required at least once per 12 month period. 
* Unsuitable environmental conditions include but are not limited to; Excessive hot or cold, Weather extremes. 

 

Reverse Osmosis Undersink Kits 

 

 

 

 

 

 Twin O-Ring Housings 

General Warranty 

Water Filter Systems¹ (Excluding consumables) Manufactured or Assembled² by Filter Systems Australia (FSA) are 
covered under a 12-month Warranty Against Defects (Manufacturer’s Warranty). This warrants the water filter system 
to be free from defects in material and workmanship for a period of 12 months from date of sale.  

If applicable, FSA may cover the return freight in the form of a re-imbursement after the system has been inspected 
and confirmed it is a valid warranty claim. 

FSA will not cover any labour charge incurred by the consumer for the replacement or repair of a product. The 
warranty is strictly parts only for the parts supplied by FSA. This warranty only applies to the original consumer of the 
product and is non-transferable. If you have purchased the system through a re-seller, please contact them to facilitate 
the warranty on your behalf. All replaced or exchanged parts become the property of FSA. 

FSA does not cover the workmanship of the plumber who originally installed the system. Responsibility for damages 
that occur during installation fall with the plumber. 

Qualification for Warranty 

As per Australian Plumbing Codes, all filter systems must be installed by a qualified plumber. The consumer is 
responsible for keeping record and proof of installation in the form of an invoice and/or receipt. 

Filter systems must be maintained as per FSA recommendations³ including the use of replacement filters, fittings and 
components supplied by FSA. Failure to maintain the filtration systems using FSA supplied/approved products may 
void warranty.  

The warranty only applies if the product was used and/or installed in accordance with the user guide and/or installation 
instructions. This warranty is given in lieu of all other express or implied warranties and manufacturer shall in no 
circumstance be held liable for damages consequential or otherwise or delays caused or faulty manufacturing except 
as excluded by law. 

Warranties need to be approved by FSA to ensure the product was not incorrectly used, installed or claimed. False 
and incorrect claims will be pursued at FSA’s discretion including chargeable inspection and transit costs incurred.  

FSA does not take responsibility for retaining customer records, it is the consumer’s responsibility to retain all invoices 
or proof of purchase from the original sale and ongoing maintenance records as proof of upkeep. 

Warranty Exclusions 

FSA Standard Warranty shall be void if the product sustains damage or failure resulting from 
any of the following: 

 

If your system(s) fails to be maintained in accordance with recommended servicing and as per the 
manufacturers operating instructions. 

 

Unauthorised or abnormal use or operation. 

 

Exposure to unsuitable environmental conditions*. 
 

FSA does not cover the work of the plumber who originally installed the system. 

Warranty – Australia 

This warranty is given by Filter Systems Australia (Jacknel Pty Ltd ATF The J & N Family Trust). ABN 64 855 305 562 
Located at 1/38 Jade Drive, Molendinar QLD 4214. Ph 07 5597 4585 & email 

[email protected]

  

This warranty is provided in addition to other rights and remedies you have under law. Our products come with 
guarantees which cannot be excluded under the Consumer Guarantees Act. 

Summary of Contents for GT1-70












Reviews: