FS M6500 Series, Configuration Manual

Page: 146 / 185

M6500 Series NE Configuration Manual
145
 Far-end monitoring point: according to received BEI.
 The direction of performance monitoring points: ingress and egress.

Monitoring Cycle: 15 minutes, 24 hours.
9.1.3. Enable Performance Monitoring Point
When the current 15-minute performance monitoring point is enabled, all the performance monitoring
parameters of the performance monitoring point are enabled at the same time, so when the performance
monitoring point is enabled, the relevant data of the current performance statistics can be viewed. The 24-hour
performance monitoring operation is the same as the 15-minute operation, as shown in the figure below:
Figure9-1 Enable Monitoring Points
Since the enablement of performance monitoring point will affect the NE performance, currently up to 500
performance monitoring points (including 15 minutes and 24 hours) for a single network element are
supported. However, if there are more than 500 points, then the system will prompt the operation failure, as
shown in the figure below:
Figure9-2 Operation Failure
Each performance monitoring point can be enabled individually by modifying the status with the button
behind it (Disable PMP
→
Enable PMP), as shown in the figure below: