4
EN
Installation Requirements
NOTE:
It is recommended to use Internet Explorer 8.0 or above to access the switch. If the
web interface of the Industrial Managed Switch is not accessible, please turn off the
anti-virus software or firewall and then try it again.
Indicates the Switch has power.
Indicates the Switch has power.
LEDs
Description
Status
P1
P2
Green
Light
Blink
Orange
Light
Off
Green
Green
Green
Green
Green
Indicates power failure.
Indicates that the ERPS Ring has been created successfully.
Indicates that Switch has been enabled to Ring Owner.
SYSTEM
RJ45
Fault
Ring
R.O.
Indicates the link through that port is successfully
established.
Indicates that the Switch is actively sending or receiving
data over that port.
Indicates that the port is successfully connecting to the
network at 1000Mbps.
Indicates that the port is successfully connecting to the
network at 10Mbps or 100Mbps.
LINK/ACT
1000
Green
Light
Blink
Orange
Light
Off
SFP
Indicates the link through that port is successfully
established.
Indicates that the Switch is actively sending or receiving
data over that port.
Indicates that the port is successfully connecting to the
network at 1000Mbps.
Indicates that the port is successfully connecting to the
network at 100Mbps.
LINK/ACT
1000
Before you begin the installation, make sure that you have the following:
Workstations running Windows XP/2003/Vista/7/8/10/2008, MAC OS X or later, Linux, UNIX, or
other platforms are compatible with TCP/IP protocols.
Workstations are installed with Ethernet NIC (Network Interface Card).
Ethernet Port Connection
Network cables -- Use standard network (UTP) cables with RJ45 connectors.
The above PC is installed with Web browser.