HEATED LANDING ZONE
CHAPTER 3: INSTALLATION AND OPERATION
3
The
Heated Landing Zone
or
HLZ
is designed to hold assembled sandwiches. By circulating heated
air evenly across the open staging area, the Heated Landing Zone keeps sandwiches hot without
drying or cooking. The Heated Landing Zone meets all McDonald’s standards for safety, efficiency,
food safety, and cleanliness.
3.1 HLZ Installation/Setup
Upon arrival, inspect the HLZ for concealed damage. Immediately report any damage to the delivering
freight company. Claims must be filed within 15 days after receipt of the unit.
Make sure that the unit is placed on an even surface and that the area surrounding the HLZ is free of
clutter that would interfere with airflow.
Install Optional Burger Bumper (Units Built Before 10/98)
The burger bumper may be placed on either side of the HLZ to prevent
pass through of product. Burger bumpers are provided by the KES.
See Figure 1.
Install Filter Screen (Units Built After 10/98)
The filter screen is design to prevent debris from entering the computer
Cowl Assembly and clogging the blower assembly. Simply fit the part
on to the vent opening of the computer cowl assembly. The filter
screen will snap into position. If equipped with an optional holding
screw, tighten screw to pull the filter screen snug into position.
Power Requirements
•
Voltage – Two models are available: 208 VAC and 240 VAC*
•
Frequency - 60 Hz
•
Single
Phase
•
20 amp Service
3.2 HLZ Operation
1. Plug the unit into the power source.
2. See
Chapter
5,
Computer Operation and Programming
, for proper computer
setup and operation.
3. Place product in the HLZ in accordance with the restaurant’s established
procedures.
4. When closing the store, remove all product from the HLZ and perform daily
preventive maintenance in accordance with the MRC. Turn the computer
OFF.
Figure 1
Optional Burger Bumper
Installed (before 10/98)
Computer
Cowl
DANGER
If the 240 VAC model is
operated on 208 VAC, the
unit will heat slowly and
may not reach maximum
temperature. If the 208
VAC model is operated on
240 VAC, component
damage is likely. To
ensure proper operation,
the power source should
match the voltage on the
rating plate on the bottom
of the HLZ.
The filter screen snaps into place on
rear of the air-intake tower.
THIS APPLIANCE IS EQUIPPED WITH A GROUNDING PLUG FOR YOUR PROTECTION
AGAINST SHOCK HAZARD AND MUST BE PLUGGED INTO A PROPERLY GROUNDED
RECEPTACLE. DO NOT CUT OR REMOVE THE GROUNDING PRONG FROM THIS PLUG.
ALL UNITS (CORD CONNECTED OR PERMANENTLY CONNECTED) SHOULD BE
CONNECTED TO A GROUNDED POWER SUPPLY SYSTEM.
