Instruction Manual for ESC Neuron 40/60/80
Instruction Manual for ESC Neuron 40/60/80
NOTE: Please don't turn on the braking function, otherwise, frequent
braking will lead to electric regulation overheating damage.
Here is the interface of Sbec_v1.0.lua.
Demag Compensation is meant to protect the motor from stalling which is
caused by over demagnetization of coils. A sudden and sharp increase of
throttle (especially at low RPM) will lead to the stalling or stutter of the motor.
Under the circumstance, Demag Compensation is an appropriate way to fix
the problem.
Motor Timing can be set from 1% to 31% with 10 increments or operate
automatically. A medium setting could make the motor work perfectly, however,
if the motor stutters, it is advised to increase timing.
Maximum Acceleration can be set between 0.1%/ms and 25.5%/ms. It can
also be set to maximum, thus acceleration is not limited. It functions as a
backup parameter. For example, if the setting goes to 10.0%/ms, it means the
power of the motor is not allowed to increase by more than 10% per millisecond
.
The Minimum Throttle can be adjusted from 900 to 1615. The value for the
settings ( Minimum Throttle, Maximum Throttle and Center Throttle) are
designed for normal input signal (from 1000 s to 2000 s). For other input signal,
the value must be scaled. For Dshot iuput signal, the setting doesn’t work.
The Maximum Throttle can be adjusted from 1140 to 2100.
The Center Throttle can be adjusted from 1001 to 2099. It is only used for
bidirectional operation.
Brake On Stop can be set between 1% and 100% or inhibited.
Sets the strength of beacon beeps. The ESC will make beacon beeps of the
signal of throttle has been zero for a given time. Note that set a high beacon
stength will lead to the heating of motors and the ESC.
Sets the delay before beacon beeping starts.
The PWM frequency of motors could be programmed between 16kHz and 48
kHz. Higher PWM frequency will make motors run smoother.
Smart Port
All data measured by S. Port supported products could be passed back to the transmitter.
Smart Port (S. Port) is a signal wire full duplex digital transmission interface developed by FrSky Electronic Co., Ltd. All
products enabled with
Smart Port (including XJT module, RX8R receiver, new hub-less sensors, new Smart Dashboard, etc), serial
port user data and other user input/output devices can be connected without limitations for numbers or sequences at a high transmis
sion speed.
Warnings
Before using the ESC, please read through the manuals of all power devices and models. Ensure rational
power configuration, or it will make the unit overloaded and damaged.
Always keep your model away from unsafe elements, such as concrete buildings and high-voltage power
lines. Fly your models according to the manual strictly, or it may cause damage and serious injuries.
Always disconnect the batteries from the ESC after use, or it may drive the motor to rotate and cause injuries.
If the ESC is connected to the battery for a long time, the battery will be fully discharged, which may lead to
the malfunction of both batteries and the ESC.
Here are the interface of parameter configuration and feedback on OpenTX.
Parameter configuration Telemetry feedback
