c. Assemble speakers, bridges, and tiles
1. Remove the front grill from a speaker.
Insert the back of the speaker up
through the hole you've cut in the tile
and then through the hole in the tile
bridge. Be sure the finished side of the
tile is facing downward (toward the front
of the speaker) and that the ends of the
tile bridge are flush with the edges of
the tile.
2. Fold out the speaker support tabs.
3. Tighten the mounting screws to
compress the tile bridge and tile
between the mounting tabs and
the speaker front. The speaker should
be snug against the tile and bridge.
4. Feed speaker wire through opening at
the top of the speaker back can.
5. Attach speaker wire to terminals. Be sure to match red wire to red terminal and black wire to black terminal.
6. Secure back can to tile bridge by folding clips into the four slots in the bridge.
7. Tighten wire clamp to secure speaker wire.
8. Reattach speaker front grill.
d. Replace tiles
Drop the tile/speaker assembly back into position in the tile grid by tilting it slightly, lifting it above the frame-
work, and letting it fall into place. Be certain that the two short sides of the metal tile bridge are resting on
top of the T-bar rails holding the ceiling tiles in place, and that the speaker wire is free for routing in Step 8.
e.
Speaker wires
a.
MINIMIZE
speaker wiring and save time by daisy-chaining in parallel left and right speakers.
Running individual speaker wire from each speaker to the terminal block on the receiver is not
required.
b.
DO NOT
coil up the excess speaker wire. Excess speaker wire should be trimmed and used for
other speakers, if possible.
c.
AVOID
bundling sensor cables and speaker wires together (except for final run from ceiling to
receiver unit). We recommend leaving at least 6 in. (15cm) between the two whenever possible.
17
2
3
1 8
tile bridge
tile
4 7
6
5
Summary of Contents for Lasso
Page 1: ...lasso INSTALLER GUIDE ...
