3
3.
“Ethernet”
– The last step is to assign the IP address and any other network settings per the room and school location.
a. IP Address = Room address
b. Subnet Mask = School’s subnet
c. IP Router = School’s IP router address
d. Remote Port = 7262
4.
SAVE
network settings. Your browser will display that the web site cannot be reached, that is OK as the CB6000 IP range
is now different than the IP range of the laptop.
5.
Next change the network settings of the CM3000 using the same procedure.
Adjusting the CM3000 Serial Port
Introduction:
When downloading the projector configuration files it is important to note that the CM3000 serial port Baud
rate must be set identical to the projector that will be controlled by the CB6000.
Description:
How to change the serial port (also known as com port or RS232) Baud rate to match that of the projector.
• Connect via Ethernet to the CM3000 from your computer/laptop
• Power up the CM3000 using the provided power supply
• Log onto the CM3000 using a web browser and enter the default IP address
192.168.1.103
• If log-in is successful you will see the main page of the CM3000, if not you will need to check your computer’s network settings.
• Have the appropriate projector specific Baud rate available
From the CM3000 web page do the following:
1.
“Serial ports”
– Select the appropriate Baud rate and then click on SAVE
