DANGER
Electric Shock Or Fire Hazard
READ ALL WIRE SIZING, VOLTAGE REQUIREMENT AND SAFETY
DATA AVOID PROPERTY DAMAGE AND PERSONAL INJURY
SAVE THESE INSTRUCTIONS
Fixing the Plug-in stand on transmitter
2.Push upward.
3.Pull stand
off back plastic
housing.
1.Insert “ " head
screw-driver
into position
shown above.
4.Hold the stand with hand,
press it vertically against
the “groove” originally
is to store the stand.
5.Glide the “stand”
downward.
Make sure
the “stand”
faces to
correct
direction.
6.The stand is now fixed.
Pressing “stand” downward,
as shown in picture above, can
take it off from back housing.
Replacing batteries in Transmitter
Flip to open the flap on
front plastic housing.
Upper compartment
2 x 1.5V AAA for powering
transmitter.
Lower compartment ,
2 x 1.5V AAA for backlit.
1. Slide selector pointed to “RUN”.
2. Press
to enter clock adjusting.
3. Press
or
to select the day of week.
4. Press
again to enter adjusting hour of day.
5. Press
or
to adjust.
6. Repeat procedure of pressing
and
/
to
finish adjusting minute of hour.
7.LCD display shall automatically return to main page 5
seconds after clock adjusting completed.
Adjusting clock before programming
Transmitter thermostat
If there is another user nearby,
e.g. in the next house, installs the
same RV-0356 unit, your receiver
may be fault triggered by his/her
transmitter. You may select a
different RF address code to prevent
this. Receiver can only response
to RF coding with the same
address code setting as its
own address code.
with the same arrangement.
Position both Transmitter and
Receiver DIP-Switches
RF Address Code Setting
