Safety
6
SAFETY & INSTRUCTIONAL DECALS
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
Replace Immediately If Damaged!
Use a clean, damp cloth to clean safety decals.
Avoid spraying too close to decals when using a pressure washer; high-pressure water can enter through very
small scratches or under edges of decals causing them to peel or come off.
Replacement safety decals can be ordered from your dealer.
9
Installation
ATTACHING
Note: Begin with the skid steer carrier adapter lying flat on the ground in front of the tractor with the hooks furthest
away.
1.
Place the transmission in NEUTRAL and start
the engine.
2.
Raise the loader boom just off the ground and
tilt loader carriers (D) forward by extending
loader carrier cylinders
3.
Drive forward and center the loader carriers (D)
under and in between the hooks (C) on the
adapter.
4.
Raise the loader boom until the loader carrier
(D) engages the hooks (C) on the adapter.
5.
Retract loader carrier cylinders and tilt loader
carriers (D) backward until adapter locking pins
(F) engage carrier holder straps (E) on each
side of the adapter.
6.
Raise the loader boom 460 mm (18 in) above
the ground.
7.
Set the park brake and place the transmission
in PARK (if applicable). Shut off engine and
remove ignition key.
8.
Remove quick-lock pins (A) from the storage
position (B) on each side of the adapter and
install into adapter locking pins (F).
INSTALLATION
ATTACHING AND DETACHING ADAPTER
WARNING
■
■
Do not operate this product until you have
positive indication that this attachment is
securely mounted to the loader. Failure to install
lock pins could result in injury or death by falling
attachment.
