RRSTUNI_REV_A05
3
5
Joiner Hole
T-slot Channel
U-Channel
RACK ASSEMBLY - SIDE PROFILES
2
7KH6LGH3URğOHVDUHVXSSOLHGLQSDLUV
7DNHRQHSURğOHIURPHDFKSDLURQHVKRUW
and one long (Except for the 2772mm long
6OLPOLQH,,UDFNZKHUHWKH6LGH3URğOHVZLOO
be equal length. Even though both pairs
are the same length it is still important that
\RXWDNHRQH6LGH3URğOHIURPHDFKSDLU
,I\RXORRNDWWKH6LGH3URğOHV\RXZLOOVHH
that at one end there is a hole that goes
through the top and bottom of the
"U" Channel.
5HIHUWR,PDJH7KHVHDUHWKH
Joiner Holes that you will be using.
4MM
,QVHUWD7KLFN-RLQHU,WHPLQWRWKH
8&KDQQHORIWKH6LGH3URğOHOLQLQJ
XSWKHğUVWKROHZLWKWKHKROHLQWKHVLGH
SURğOHDVVKRZLQ
1RZJUDED7KLQ-RLQHU,WHPDQG
1\ORF1XW,WHP6OLGHWKH-RLQHULQWRWKH
"T-slot", followed by a Nyloc Nut.
The Nyloc Nut should sit on top of the
Thin Joiner with the "Dome" of the
Nyloc Nut facing up. Line up the outer
hole of the Thin Joiner and Nyloc Nut with
the Joiner Hole and loosely fasten it all
together using a M8 x 45 Button Head Bolt
,WHPDQGDPP$OOHQ:UHQFK
6OLGHWKHPDWFKLQJ6LGH3URğOHRYHUWKHWZR
Joiner pieces, remembering to insert a
Nyloc Nut, and fasten once again using a
M8 x 45 Button Head Bolt. Repeat the above
steps for the other side.
2.1
2.2
,I\RXKDYHUHFHLYHGIRXUOHQJWKVRI6LGH3URğOH,WHP\RXZLOOQHHGWRMRLQWKHSLHFHVWRJHWKHUXVLQJWKH-RLQHUV
,WHPV WRIRUPRQO\WZROHQJWKVE\IROORZLQJWKHHDV\VWHSVEHORZ
:LWKWKHH[FHSWLRQRIWKHPPORQJ6OLPOLQH,,7UD\WKHMRLQWVLQWKH6LGH3URğOHZLOOEHGLDJRQDOO\RSSRVLWHHDFKRWKHU
once the Tray is assembled.
127(6NLSWKLVVWHSLI\RXU6OLPOLQH,,7UD\LVPPRUVKRUWHU\RXZLOORQO\KDYHWZR6LGH3URğOHVDQGDVVHPEO\
is not required.
5MM
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
2
3
4
1
5MM
