Installation | 5
M2050222_en | Installation instructions Lambdamat LM 1500 KOM
37
5.6.12 Fitting the combustion chamber ash removal unit (optional)
The ash container for removing ash from the combustion chamber by ash screw can be
fitted to the right or left-hand side of the boiler. The following steps show how to fit it to
the right-hand side of the boiler. If the ash container is to be fitted to the left, the steps are
the same but on the opposite side.
1
2
3
4
r
Undo the screws on the ash removal flange and fit the clamping plate
r
Push the ash screw (1) into the right of the combustion chamber
r
Fit the ash removal unit flange (2) with seal to the right of the combustion chamber
r
Fit the safety switch (3) to the bracket (4)
r
Fit the bracket (4) to the insulating side panel
1
2
3
4
r
Slide the sensors into the clamping plate
r
On the opposite side of the combustion chamber, put the washer (1) onto the shaft
stub
r
Fit the flange plate (2) with the seal (3) and the flange bearing (4)
