54
7.2 Measurement Specifications
The following table provides the specifications for the measured parameters.
Measurement
Range
Accuracy
Resolution
Indoor Temperature
0 to 60 °C
± 1 °C
0.1 °C
Outdoor
Temperature
-40 to 65 °C sensor
-5 to 60 °C battery range
(alkaline)
± 1 °C
0.1 °C
Indoor Humidity
1 to 99%
± 5%
1 %
Outdoor Humidity
1 to 99%
± 5%
1 %
Barometric
Pressure
300-1100hPa
(8.85 to 32.50 inHg)
+/-3hpa under 700-
1100hPa
0.1hPa
Light
0 to 400,000 Lux
± 20%
1 Lux
Rain
0
–
9999mm
± 10%
0.03mm
Wind Direction
0 - 360 º
10º
1º
Wind Speed
0-50m/s
± 1m/s or 10% (whichever
is greater)
0.1 m/s
7.3 Power Consumption
•
ObserverIp Receiver : 5V DC Adaptor (included)
•
Indoor Thermo-hygrometer-barometer sensor : 2xAAA batteries (not included)
•
Outdoor sensor array: 3xAA alkaline batteries (not included)
1. Maintenance
1. Clean the rain gauge once every 3 months as follows. Reference Figure 23.
Step 1:
Make a note of the current rain totals by referencing the calibration panel
(reference Section 0). You will need to re-enter these values after the calibration
procedure
it
complete.
Step 2:
Pour water into the rain collector to moisturize the dirt inside rain bucket.
Step 3:
Use an approximately 3 inch (80 mm) long cotton swab, and push the cotton
tip through the rain collector hole until is reaches the self emptying mechanism, and
press
until
the
mechanism
no
longer
rotates.
Step 4:
Rotate the cotton swab back and forth, removing dirt from the tipping
mechanism
and
rain
collector
hole.
Summary of Contents for IP Observer WH2600 SE
Page 1: ...1 WH2600 SE WH2601 SE Benutzerhandbuch Internet Wetterstation ...
Page 28: ...28 Figure 6 ...
Page 48: ...48 Figure 22 Figure 30 ...
Page 56: ...56 Figure 25 ...