Frigidaire GLHV30T4KC, Owner'S Manual

Page: 8 / 20

8
Be sure lights are cool before cleaning the hood.
To Clean Filters To Clean Filters
To Clean Filters To Clean Filters
To Clean Filters
• •• • • The metal grease filters will last forever.
They are made of anodized aluminum
• ••
•
• It is recommended that the filters be washed at least once a month; they
can be washed by hand or in the dishwasher.
• Drain water through edge holes and let each filter dry thoroughly before
replacing it.
To Remove The Metal Grease Filters To Remove The Metal Grease Filters
To Remove The Metal Grease Filters To Remove The Metal Grease Filters To Remove The Metal Grease Filters
• Turn blower and lights off.
• Push simultaneously the two handles S first upwards, then towards the
center and extract the filters Figure 10.
To Replace The Metal Grease Filters To Replace The Metal Grease Filters
To Replace The Metal Grease Filters To Replace The Metal Grease Filters To Replace The Metal Grease Filters
• Reverse procedure.
To Replace The Carbon Filter To Replace The Carbon Filter
To Replace The Carbon Filter To Replace The Carbon Filter To Replace The Carbon Filter
• The Carbon Filter must be replaced once a yera in normal use.
• To dismount push the two locks D and extract it from its housing.
To Clean Hood Surface To Clean Hood Surface
To Clean Hood Surface To Clean Hood Surface To Clean Hood Surface
• For general care, wipe the outside of the stainless steel, white, black or
glass hood with sudsy water or household cleaners such as Fantastic® or
Formula 409
® , rinse well and dry with clean soft cloth to avoid water marks.
• Wipe and dry brushed stainless steel in the same direction as the grain.
• Do not use abrasive products.
• To remove finger prints and give added shine use spray cleaners such as
Stainless Steel Magic ® and Shimmer ® .
Hood Cleaning Hood Cleaning
Hood Cleaning Hood Cleaning
Hood Cleaning
NOTE: Turn blower and lights off. Make sure the lights are cool. Turn blower and lights off. Make sure the lights are cool. Turn blower and lights off. Make sure the lights are cool. Turn blower and lights off. Make sure the lights are cool. Turn blower and lights off. Make sure the lights are cool. If new
lights do not operate be sure lights are inserted correctly before calling
service.
• Remove the light shield Q Q Q Q Q by pushing simultaneously the two unlocking
buttons R R R R R (Figure 12); for safety reasons make sure to remove the light
shield from its suspension slides G G G G G.
• Pull out fluorescent tube and replace with Philips Type PL-S 9 Watt
maximum.
• Refit the light shield.
Lights replacement Lights replacement
Lights replacement Lights replacement Lights replacement
Figure 10 Figure 10
Figure 10 Figure 10 Figure 10
Figure 12 Figure 12
Figure 12 Figure 12
Figure 12
R R R R R
Q Q Q Q Q
G G G G G
Figure 11 Figure 11 Figure 11 Figure 11 Figure 11