13
Fig. 1
Fig. 2
Dual radiant surface elements
You may switch element size settings at any time while
cooking.
on cooktop
SETTING SURFACE CONTROLS
Radiant surface elements may appear to have cooled
after they have been turned off.
The glass surface may
still be hot
and burns may occur if the glass surface is
touched before it has cooled sufficiently.
Do not place flammable items
such as plastic salt and
pepper shakers, spoon holders or plastic wrappings on
top of the range when it is in use.
These items could melt
or ignite. Potholders, towels or wooden spoons could
catch fire if placed too close to the surface elements.
CAUTION
The size and type of utensil used, and the amount and
type of food being cooked will influence the setting
needed for best cooking results.
NOTES
The
HE
(hot element) message will appear in the display
windows once a heating element is turned OFF and will
remain ON until the heating surface area or areas have
cooled sufficiently.
Do not allow aluminum foil, or ANY material that
can melt to make contact with the ceramic glass
cooktop.
If these items melt on the cooktop they will
damage the ceramic cooktop.
IMPORTANT
The cooktop provides 1 or 2 dual radiant surface elements,
depending on your model type. Indicator lights located on
the backguard show which portions of the dual radiant
element are set to heat. The symbol indicates the inner
coil only and should be used with smaller cookware (Fig. 1).
The symbol indicates both inner and outer coils will heat
together and may be used for larger cookware (Fig. 2).
A glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is
too
small
for the surface heating area.
Start most cooking operations on a higher setting and then
set to a lower setting to finish cooking. See the
Suggested
power level settings table
(provided in the instructions
for the single radiant elements)
1. Place correctly sized cookware on
the dual radiant surface element.
2. Press and hold the
on-off
for the desired element position
until a beep is heard.
3. Press the element
size
(once for inner or twice for both).
4. Press
lo, med
(5.0)
or
hi
.
Each touch of the
lo
or
hi
pad will
decrease or increase the power
level by 1/2 from
9.5
through
3.0
.
Simmer power levels between
3.0
and
1.2
will decrease or increase
by .2 increments.
lo
is the lowest
power level available.
5. Once cooking has
completed, press
on-off.
Step
Press
To operate dual radiant surface elements:
,
,
on cooktop
indicator light
indicator light
