Cleaning and maintenance
Unplug the refrigerator before starting to clean it.
Never clean the refrigerator with flammable fluids such as alcohol, kerosene,
gasoline, thinner, solvents or chemical / abrasive products like detergents, acids
or vinegar. Cleaning products such as powdered detergents, abrasive cleansers,
alkaline cleansers, chemically treated cloths, solvents, alcohol and even hot water
should also not be used to clean the refrigerator, as they can damage the paint and
the plastic parts.
If you are not going to use the refrigerator for an extended period of time, unplug it,
clean and dry the inside, and then close it properly.
Do not clean the Refrigerator by throwing water directly on it, neither on the
outside, nor on the inside.
Inside
Before cleaning, remember that humid objects adhere easily to extremely cold
surfaces. For this reason, do not touch these surfaces with damp cloths, objects
or hands.
Clean the inside of the refrigerator with a cloth dampened in a solution of warm
water and baking soda (one spoonful of baking soda for each liter of water).
Never use metallic objects, brushes, abrasive or alkaline products to clean the
plastic surfaces inside the refrigerator.
Plastic parts should not be washed in hot water.
Door seals
The rubber door seals should be carefully cleaned with a damp cloth. Rinse and
dry them carefully to avoid damage.
Outside
Clean the outside of the refrigerator with a damp cloth dipped in warm water and
mild soap.
Once every 6 months, clean the back of the refrigerator with a vacuum cleaner or a
duster. The dust that accumulates there interferes with proper functioning of the
condenser, and therefore of the refrigerator, leading to higher energy
consumption. Disconnect the refrigerator before cleaning and do not touch the
condenser or the compressor, as they may be hot.
The drainage tray should be cleaned at least once a year.
Water will enter the refrigerator if the drainpipe becomes blocked; if this happens,
disassemble the light protector and wash out the drain pipe.
Substituting the light
When you need to replace the light, follow this instructions below:
1. Unpplug the power cord
2. To remove the light ratate it to the clockwise.
3. Replace the light with problem to another one with the same dimensions and
power.
A) Freezer room:
Insert a coin into the lower slot and take out the cover window. Replace the small
lamp with a new one using the right spare (15 W base E-14, 120V~), place the
cover into the window.
B) Refrigerator room:
Take out cover window with the hand, replace the small lamp with a new one
using the rigth spare (25 W base E-26, A-15, 125V~). Place the cover in the
window.
4. Connect the pulg to the power supply line after 5 minutos.
Cover window
Temperature control
Lamp
Cover window
Cover
Window
39
40
ENG
ENG
