Frigidaire FNVV60GGEWT, User Manual

Page: 8 / 35

3.3 ELECTRIC CONNECTION AND SECURITY
During the electric connection, be sure to follow the instructions below.
The earthing cable must be connected to the terminal. Ensure that the
cable with insulation is connected to the power source during the connection of
cable. If there is not any appropriate earthed electric outlet in accordance with
regulations in the place where the oven will be installed, immediately contact
the authorized service.
The earthed electric outlet must be close to the oven. Do not use an
extension cord.
The feeding cable must not touch any hot surface of the product.
In case the feeding cable is damaged, contact the authorized service. The
cable must be changed by the authorized service.
The wrong electric connection may damage your oven, which may not be covered
by the guarentee.
The oven is adjusted as appropriate for 220-240 Volts and 400V 3N Volts
of electricity. If the network electricity is different than this informed value, immediately
contact your authorized service.
The electric cable must not touch the hot parts of the oven. The electric cable
must not touch the back part of the oven. Otherwise the electric cable of the
oven may be damaged which may cause a short circuit.
The manufacturer declares that it has no responsibility against any kind of damages
and losses that are caused bythe following security norms.
There is to install an all pole disconnector inside the supply circuit with a contact
opening of at least 3.0mm rated 32A and delay functioning type.
The appliance is provided for fixed connection to the power supply. The connection
of the appliance to an electrical source must be done by authorized technician.
6
3. 2 ADJUSTMENT OF FEET
Your oven stands on 4 adjustable feet. Be sure the oven is balanced before installation
If required, you can adjust the feet by turning the feet clockwise. It is also possible to
raise the oven a maximum of 15 mm with the feet.
If the feet are adjusted appropriately, do not move the oven by dragging it, only move
it by lifting it up and carrying it. It is required to take the oven's drawer out in order to
adjust the oven's feet. The feet can be adjusted from inside .
The supply cable must not touch to the hot surface of the product.