Frigidaire FHPC082AC1, Use & Care Manual

Page: 6 / 18

Installation Instructions
Installation Instructions
EXHAUSTING HOT AIR
In the Cool Mode the appliance must be placed close to a
window or opening so that the warm exhaust air can be ducted
outside.
The hose can be extended from its original length of
15"up to 59",but it is the best to keep the length to
minimum required. Also make sure that the hose does
not have any sharp bends or sags.(Fig.5)
First position unit on a flat floor and is within the vicinity of a single
circuit outlet power source. Make sure there’s a minimum of 31.5"
clearance in the front/back of the unit, and a minimum of 19.7"
clearance in the left/right sides of the unit.
31.5"
19.7"
Vertical
window
Window Slider Kit
Minimum:26.6 (67.5cm)
Maxmum:52.5 (133cm)
Fig.3
Horizontal
window
Window Slider Kit
Minimum:26.6 (67.5cm)
Maxmum:52.5 (133cm)
Fig.4
Fig.5
Fig.2
Slide onto
1. Extend either side of the hose(Fig.1A) and screw the hose to
connector A(Fig.1B).
2. Extend the other side of the hose and screw it to adaptor B(Fig.1C).
3. Install the connector B into the unit (Fig.2).
4. Affix the connector A into the window slider kit and seal.(Fig.3&4)
Fig.1A
Extend the side of hose
Fig.1B
Fig.1C