Frigidaire FFPA1422R1, Use & Care Manual

Page: 7 / 14

7
(continued)
2009 Electrolux Home Products, Inc. All rights reserved.
Installation in a double-hung sash window
3. Close the window sash securely against the window slider kit. (Fig. 13)
7. Cut the foam seal to an appropriate length and seal the open gap
between the top window sash and outer window sash, as shown in Fig.15.
2. Open the window sash and place the window slider kit on the window stool
(Fig. 11). Attach the window slider kit to the window stool. Adjust the length
of the window slider kit according to the width of window. Screw down the
two screws on the window slider kit. See Fig.11. Cut the adjustable window
slider kit if the width of window is less than 26.6 inches (Fig. 12).
1. Cut the foam seals(adhesive type) to the proper lengths and attach them
to the window and stool. (Fig. 10)
Installation in a sliding sash window
3. Close the sliding sash securely against the window slider kit. (Fig. 18)
1. Cut the foam seals(adhesive type) to the proper lengths and attach them
to the window frame. See Fig.16.
2. Open the window sash and place the window slider kit on the window stool.
See Fig.17. Attach the window slider kit to the window stool. Adjust the
length of the window slider kit according to the height of window. Screw
down the two screws on the window slider kit. See Fig.17. Cut the adjustable
window slider kit if the height of window is less than 26.6 inches (Fig. 12).
6. Cut the foam seal to an appropriate length and seal the open gap
between the sliding sash and outer window sash, as shown in Fig.19.
Fig. 10
Foam seal A
(adhesive type)
Fig. 16
Foam seal
(adhesive type)
Installation Instructions
Installation Instructions
Fig. 19
Foam seal
Fig. 11
Window slider kit
Window stool
26.6"~48.5"
screws
Fig. 20
Fig. 12
Cut this side to fit your window
4. Drive two 1/2" screws to secure the window slider kit to the window sash.
(FIG. 1 3 )
6.
To secure lower sash in place, attach right angle sash lock with
1/2 ″ (12.7mm) screw as shown (FIG. 1
4
).
NOTE:
It is difficult to lock the windows with the sash lock for Vinyl-Clad
windows, so you can use lock by window itself.
7. To secure the sliding sash in place, attach right angle sash lock with 1/2"
(12.7mm) screw as shown.(Fig.20)
5. Secure the window slider kit to the window stool
(FIG. 1 3 )
:
A: For wooden windows: Use 3/4" screws for securing.
B: For Vinyl-Clad windows: Use
1/2 ″ hex head cap screws
for securing.
4. Drive two 1/2" screws to secure the window slider kit to the window sash.
(Fig. 18)
5. Drive two 3/4" screws to secure the window slider kit to the window stool.
(Fig. 18)
Fig. 14
Fig. 15
Foam seal
3/4 ″ screws or 1/2 ″
hex head cap screws
1/2 ″ screws
Fig. 13
Window slider kit
Window stool
screws
Fig. 17
26.6"~48.5"
Window stool
Window slider kit
3/4 ″ screws
1/2 ″ screws
Fig. 18
Window stool
Window slider kit