ground coffee powder tightly with the tamper.
2. Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from the “Insert” position, and you can fix them
into coffee maker firmly by turning it anticlockwise until it is at the
lock
position.(See fig. 1).
3. Remove the cup from the cup warming plate. Then place the hot cup (your cup) on removable cup
shelf.
4. At the time, the ready indicator (green) is illuminated, once the green lamp is illuminated, you should
press down the pump control button to the lower position which is
the “
” position, to let the coffee
flow out.
5. You should press and release the ON/OFF button to the higher position which is the
“
O FF
” position
manually when desired coffee is obtained or the colour of coffee changes weak obviously or the
power indicator and ready indicator go out and the coffee maker stops working, your coffee is ready
now.
WARNING
: Do not leave the coffee maker unattended during making the coffee, as you need to
operate manually sometimes!
6. After finishing making the coffee, you can take the metal funnel out by turnning clockwise, and then
pour the coffee residue out with the steel mesh pressed by press bar.
7. Let them cool down completely, then rinse under running water.
FROTHING MILK/ MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Method:
1. Prepare espresso first according to the procedure as
“MAKE ESPRESSO COFFEE”, make sure that
the steam control knob is at the minimum position.
2. Press down the coffee/steam button to the lower position which is the
position, wait until the
ready indicator (green) is illuminated.
Note:
During operation, if the green indicator is extinguished, you should turn the steam control knob to
OFF position. Then press and release the coffee/steam button to the higher position which is
the
position and press down the pump control to the lower position which is the
“
” position and
pump water, after about 30seconds, close the pump, press down the coffee/steam button to the lower
position which is the
position again, then wait for until the green indicator is illuminated and turn the
steam control knob in anti-clockwise, the steam will come out again.
3. Fill a jug with about 100 grams of milk for each cappuccino to be prepared, you are recommended to
use fresh milk at refrigerator temperature (not hot!).
Note
: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and bear in
mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
4. Insert the frothing device into the milk about two centimetre, then turn the steam control knob slowly
